Evolution – Replacing the Hose Data and Power Cables

Overview

The Hose contains two cables a Data Cable and a Power Cable. It is recommended that you remove the Hose first before attempting to replace them.

1. Carefully remove the white plugs from the Phaser end of the cable by lifting the small plastic tabs using a craft knife

Pull the wires from the plug one-by-one.

***Broken Image***

2. Gently pull the cables out of the Vest Sensor end of the hose

3. Insert the new cables into Hose by bunching the ends together and gently pushing them up the Sensor end of the hose

***Broken Image***

4. Re-tip the cables and plug them in